Jeld-wen JII040 Custom Clad Lift and Slide Door Systems Manual do Utilizador descarregar pdf

ASSEMBLY AND INSTALLATION INSTRUCTIONS

for Custom Clad Lift and Slide Door Systems (JII040)

LANDINGS

These instructions

cover two door

sill conditions: the

step-down landing

and the continuous

slab landing. The

installation methods

vary slightly between

landing types.

Newer construction methods have led to an increase in air and water

tightness in buildings. This frequently leads to negative air pressure

inside the house, which can draw water through very small openings. Our

installation method seals the door to the weather barrier (typically building

wrap) and uses a sill pan to capture and drain incidental storm water from

under the door to the exterior.

Thank you for selecting JELD-WEN products. Attached are JELD-WEN’s

recommended installation instructions for Custom Lift and Slide doors.

Read these instructions thoroughly before beginning. They are designed

to work in most existing applications, however; existing conditions

may require use of alternative methods to these instructions. If changes

are needed, they are made at the installer’s risk. For installations other

than indicated in these instructions, contact a building professional. To

adequately protect your door, please refer to “Appropriate Protection for

Exterior Doors” for information on protection requirements at

www.jeld-wen.com.

Not all exterior door types may be installed into every wall condition

in all areas. See our Appropriate Protection document for overhang

requirements at www.jeld-wen.com. Consult your local building

code ofcial (or Authority having Jurisdiction) for applicable building

codes and regulations. Local building code requirements supersede

recommended installation instructions.

Please Note! Any door installation such that the sill is higher than

35 feet above ground level or into a wall condition not specically

addressed in these instructions must be designed by an architect or

structural engineer. We recommend that all non pre-nished wood or

berglass components be nished with an appropriate paint or stain

prior to installation. See our Finishing document for details at

www.jeld-wen.com. Failure to properly nish or install square, level

and plumb and on a at surface (without peak and valleys) could result

in denial of warranty claims for operational or performance problems.

Note to Installer: Provide a copy of these instructions to the building

owner. By installing this product, you acknowledge the terms and

conditions of the limited warranty as part of the terms of the sale.

GLOSSARY

Astragal

The vertical trim attached to one of the panels of a sliding patio door

that bridges the gap between the panels when closed and provides

weather protection.

Backer Rod (backing material)

A material (e.g. foam rod) placed into a joint primarily to control the

depth of the sealant.

Buck

A wood framework attached to the masonry inside a window or a door

rough opening.

Continuous Air Seal

Backer rod and sealant or low expansion foam applied to the interior

gap between the product and the building in a continuous fashion

used to block air ow between the interior and exterior of the building

envelope.

Interlock

A weatherstrip component that runs vertically along the stiles of

either horizontal sliding sashes or sliding patio door panels. When the

window/door is closed, the interlocks engage, locking together, to

create a weather barrier.

Pilot Hole

A drilled hole that is no larger than the body of the screw (minus the

threads).

IMPORTANT INFORMATION AND GLOSSARY

Estimated Install

Time for New

Construction

First Time: 6 hr.

Experienced: 5 hr.

Professional: 4 hr.

Continuous

Slab

Landing

Step-Down Landing

Please allow sufcient time to properly prepare the rough opening,

install the door, and ensure its proper operation.

Rough Opening

The framed opening in a wall where a door is to be installed.

Shiplap

The layering method in which each layer overlaps the layer below it so

that water runs down the outside.

Sill Pan

A ashing component installed in the sill of the rough opening

underneath the door. Sill pans have upturned walls along the interior

edge and at both ends, creating a three sided box. This component

serves as a collection device to drain incidental water to the exterior of

the building and should be properly sealed to the opening. The best sill

pan design has a positive slope to the exterior and offers continuous

support to the door's sill.

1 2 3 4 5 6 7 8

Resumo do Conteúdo

Página 1 - Construction

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)LANDINGSThese instructions cover two door sill conditions: t

Página 2 - ROUGH OPENINGS

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)2MATERIALS AND TOOLSNEEDED MATERIALSNote! Follow all materia

Página 3 - INSPECT ROUGH OPENING

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)3• Backer rod 1/8" larger than the widest portion of th

Página 4 - PREPARE BUCK

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)4The sill can be prepared using one of two methods: We recom

Página 5 - PREPARE STUD - FRAMED WALL

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)56. Cut a piece of self-adhesive ashing the length of the

Página 6 - INSTALL DOOR

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)66INSTALL DOORASSEMBLE FRAME1. On a clean and at surface, l

Página 7 - INSTALL DOOR - CONTINUED

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)7INSTALL PANELSNote! To avoid damage to the rollers, clean a

Página 8 - COMPLETE INSTALLATION

ASSEMBLY AND INSTALLATION INSTRUCTIONSfor Custom Clad Lift and Slide Door Systems (JII040)8Please visit jeld-wen.com for warranty and care and mainten

Comentários a estes Manuais

Sem comentários

Jeld-wen JII040 Custom Clad Lift and Slide Door Systems Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Para a casa Jeld-wen JII040 Custom Clad Lift and Slide Door Systems. JELD-WEN JII040 Custom Clad Lift and Slide Door Systems User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Para a casa Jeld-wen JII040 Custom Clad Lift and Slide Door Systems